Filter
Top Products
5
Chapter 3: Setup Utility for the Gigabit USB Adapter
Overview
Gigabit USB Adapter
Chapter 3: Setup Utility for the Gigabit USB Adapter
Overview
This chapter will take you through all the steps necessary to set up, configure, and install the Gigabit USB
Adapter. The steps are also available to use the Utility to uninstall the driver from the Adapter, if you should ever
need to do so. After you set up the Adapter with the Setup Utility, you will install the Adapter into your Notebook
PC.
Setup Utility
1. Insert the Setup Utility CD into your PC's CD-ROM drive.
2. The Setup Utility's Welcome screen should appear on your monitor. If it does not, this means the Setup Utility
is not automatically running as it should. Start the Setup Utility manually by clicking the Start button,
selecting Run, and typing d:\setup.exe (where "D" is your PC's CD-ROM drive).
Click the Install button to continue this Setup Utility and install the driver. Click the Uninstall tab and button
to uninstall the driver. Clicking the User Guide button opened this User Guide. To contact Linksys, click the
Contact Us tab and button. To exit this Setup Utility, click the Exit tab and button.
Setup and Driver Installation
1. If you haven’t already done so, click the Install button. The Welcome screen will appear. Click Next to
continue the installation.
Figure 3-1: Driver Installation
Figure 3-2: Start the Installation
IMPORTANT: Make sure that you don’t connect the Adapter until instructed to do so or the
setup won’t work.