Filter
Top Products
77
Chapter 6: Setting Up and Configuring the Router
L2 Switch Tab
Wireless-N Gigabit Security Router with VPN
RADIUS
RADIUS mode provides authentication on devices connecting to the LAN ports. It requires installation of a RADIUS
server on your local network.
Mode. Select Enabled or Disabled, as desired.
RADIUS IP. Enter the RADIUS server IP address.
RADIUS UDP Port. Identifies the UDP port. The UDP port is used to verify the RADIUS server authentication.
RADIUS Secret. Indicates the Key string used for authenticating and encrypting all RADIUS communications
between the Wireless Router and the RADIUS server. This key must match the RADIUS server’s configuration.
Administration State. Specifies if each port needs RADIUS authentication. The defaults are Force Authorized
so no authentication is needed. The possible field values are:
• Auto. The controlled port state is set by the RADIUS Mode.
• Force Authorized. The controlled port state is set to Force-Authorized (forward traffic). All connections
can be made.
• Force Unauthorized. The controlled port state is set to Force-Unauthorized (discard traffic). All
connections are blocked.
Parameters button. Click this button to configure RADIUS re-authentication and timeout period for
re-authentication and EAP.
Change these settings as described here and click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. Help information is displayed on the right-hand side of the screen, and click
More for additional details.
Figure 6-64: L2 Switch - RADIUS
Figure 6-65: L2 Switch - RADIUS