Filter
Top Products
4
Before You Begin
Make sure you have the following:
An active Network connection
Active Internet phone service accounts and settings (if connecting to Internet phone service)
A cable/DSL modem (if connecting to Internet)
One computer for configuration of the Gateway or an analog telephone with an RJ-11 phone
cable
NOTE: If the Gateway is pre-configured by your ITSP, then you
do not need to change any of the default voice settings. Refer to
the documentation supplied by your service provider for more
information.
Power off your network devices,
including your modem and PC.
If you have an RJ-21 connector
available, you can connect to
the RJ-21 port on the back of the
Gateway. Then skip to step E. If you
are connecting individual phone
lines, go to step C.
Connect one end of an RJ-11 phone
cable to the Gateway’s PHONE 1
port. Connect the other end to your
analog telephone.
Repeat Step C with each PHONE
port if you have an additional
telephones to connect.
•
•
•
•
A.
B.
C.
D.
RJ-21 ConnectionRJ-21 Connection
RJ-11 Phone portRJ-11 Phone port
Connect1�