Filter
Top Products
- 18
After auto set-up has been completed, a message will appear
on the screen.
Example 1 - successful auto set-up:
MEASUREMENT COMPLETE
BEAM MODE : 5 BEAM
SUBWOOFER : NOT APPLICABLE
[END] : Do not save set-up.
[OK] : Save set-up.
AUTO SETUP
Example 2 - failed auto set-up:
MEASUREMENT COMPLETE
ENVIRONMENT CHECK [FAILED]
BEAM MODE : 5 BEAM
SUBWOOFER : NOT APPLICABLE
[END] : Do not save set-up.
[OK] : Save set-up.
AUTO SETUP
➠ If the message Error E-1 is displayed, repeat the
autoset-up process
. Please also
read the "Error messages for
auto
set-up
" on
page 26.
OK Apply results of auto set-up .
Remove the microphone from the Sound Projector now.
The Sound Projector is now ready.
You will find information on operating the Sound Projector
from page 19 onwards.
Saving sound set-up
You can save up to three sound set-ups. This allows you, for example, to take
different listening positions, the actual room or TV positions into consideration
when using a Loewe TV with swivel caster control. You can than call up these
sound set-ups at any time.
Press the button for a long time. The menu MEMORY
appears.
1) LOAD
2) SAVE
[] / [] : Up / Down
[OK] : Enter
MEMORY
56 Select the option SAVE.
Confirm OK.
MEMORY1
MEMORY2
MEMORY3
[] / [] : Select
[OK] : Enter
2) MEMORY SAVE
56 Select the option MEMORY1-3.
Confirm OK.
➠ All settings you adjusted in the Sound Projector menus are permanently
stored by saving.
Initial set-up