Filter
Top Products
21 -
Selecting input mode
You can select the audio input signal type of the set input signal source.
➠ In most cases, setting the input mode to AUTO is
recommended.
Select the input mode by pressing IN-MODE several times.
Signal source shown in the display
TV / AUX3 TV Auto - TV DTS - TV Analogue
AUX1 DVD Auto - DVD DTS
AUX2 AUX Auto - AUX DTS
Selecting signal source
Press AUX (PIP) several times on the remote control to select
the required signal source.
Decoder displays
Depending on the input signal source and the surround mode selected, the indi-
cators on the display of the Sound Projector light up as follows.
PCM When playing back PCM signals.
When playing back PCM or Neo:6 signals.
DIGITAL
When playing back Dolby Digital signals.
PL
When playing back Dolby Pro Logic signals.
PL
When playing back Dolby Pro Logic II signals.
Surround modes and recommended signal sources
Surround mode Recommended signal source
Neo:6 films, music
PL
All signal sources
PL
Films, music, games
➠ The surround modes are available if another sound beam mode is selected
as the stereo playback.
➠ If you select an input signal source (page 19), the surround mode that was
used for the previous input signal source selected is retained.
➠ If you switch this unit off and on again, the surround mode used for the
previous input signal source selected before switching off is retained.
➠ Surround modes are only available if the sound field programmes have been
deactivated (page 22).
➠ If you press the button on the remote control and no surround modes are
available, Prohibit will appear on the display of the Sound Projector.
➠ The surround modes are only available if 2-channel signals have been set up.
If you try to switch between surround modes when 5.1 channel signals are set up,
Prohibit will appear on the display of the Sound Projector.
Everyday use