Filter
Top Products
K8SLI
30
PCI / VGA Palette Snoop
Some graphic controllers that are not VGA compatible take the output from a VGA controller and
map it to their display as a way to provide boot information and VGA compatibility. Options:
Disabled (default)、Enabled
PCI Latency Timer (CLK)
This item allows you to set up the PCI Latency Time (0-255). If you select the “32” it will optimize
PCI speeds. Options: 0-255、32 (default)
**PCI Express relative items**
Maximum Payload Size
This item allows you to set maximum TLP payload size for the PCI Express devices. The uinit is
byte.
Options: 128、256、512、1024、2048、4096(default)
Frequency/Voltage Control
CPU Speed Detected
This item displays the CPU speed information detected by the system.
CPU Host Frequency (MHz)
This item displays the CPU Host frequency. You can set it from 200 to 450. The default depends on
your CPU frequency. The default for this field depends on the CPU installed.
CPU Spread Spectrum
The Spread Spectrum function can reduce the EMI (Electromagnetic Interference) generated.
Options: Enabled (default)、Disabled
DDR Speed (strobe/sec)
This item display the current DDR speed (CPU Host frequency * Max Memclock ÷ 100.)
Hammer Fid control
This item displays the CPU ratio information detected by the system.
Options: The options that will be available will depend on the default value of the CPU installed. For
example, if the CPU default value is 10 then the options will be from 4 to 10.
Note: Before you try to make any adjustments to this option, make sure that your CPU Ratio is
adjustable and has not been locked by the CPU manufacturer.
CPU Speed Setting
This item display the CPU speed that you setting for. If you don’t change the “CPU Host Frequency”
or the “CPU Clock Ratio” and the item will display the current CPU speed.
CPU Speed = Current CPU Host Frequency x CPU Clock Ratio,
DDR S
p
eed = Current CPU Host Fre
q
uenc
y
x
(
Max Memclock ÷ 100
)