Filter
Top Products
MegaRAID Enterprise 1600 Hardware Guide
52
Step 4 Install Cache Memory,
Continued
Installing or Changing Memory
Important
The battery pack harness or cable must be disconnected from J23 on the
MegaRAID Enterprise 1600 160M card before you add or remove
memory.
Step Action
1 Bring down the operating system properly. Make sure that cache memory
has been flushed. You must perform a system reset if operating under DOS.
When the computer reboots, the MegaRAID controller will flush cache
memory.
2 Turn the computer power off. Disconnect the power cables from the
computer.
3 Remove the computer cover.
4 Disconnect the battery pack cable from the MegaRAID controller.
5 Remove the MegaRAID controller.
6 You can now add or remove DRAM modules from the MegaRAID
controller. Follow the instructions on page 51.
7 Reattach the battery pack harness to J23 on the MegaRAID controller.
8 Reinstall the MegaRAID controller in the computer. Follow the instructions
in this chapter.
9 Replace the computer cover and turn the computer power on.
Recommended Memory Vendors
Call LSI Logic Technical Support at 678-728-1250 for a current list of
recommended memory vendors.