Filter
Top Products
LSI22902/22903 Host Adapter to Intel ISP1100 Internet Server 13
Figure 11 Removing the Hard Drive Bays
Note:
Each device on the SCSI bus, in this case, the host adapter
and hard drives, must have a unique SCSI ID. SCSI ID 7 is
the default host adapter setting. See the documentation for
your hard drives for assistance in determining and if
necessary, changing, the device’s SCSI ID. SCSI ID 0 and
1 are recommended for the two internal hard drives.
For further information about setting SCSI IDs, contact
LSI Logic Technical Support at 719-533-7230.
Step 4. Remove the IDE cable by carefully detaching it from the
mainboard connector, J27, if present.
Refer to Figure 12 for a photograph showing the cable and its location.
As noted above, it may not be present.