Filter
Top Products
Configuring RIP
Command Line Interface Protocol Configuration Guide 2
-
5
Task Command Parameter
Interface Configuration Mode
Set the RIP default route
characteristics. There is no
default.
ip rip
default-route-mode
{talk-only | listen-only |
talk-listen | none}
talk-only
- the default route
is advertised in RIP updates
but ignored on incoming
neighbor updates.
listen-only
- the default
route is suppressed from RIP
updates but accepted on
incoming neighbor updates.
talk-listen
- the default route
is advertised and accepted.
none
- the default route is not
advertised or accepted.
Specify the RIP version to
receive and send on the
interface. By default, an
interface receives and sends RIP
Version 1 packets only.
ip rip receive
version
[
1
] [
2
]
ip rip send version
[
1
] [
2
]
To accept or send only RIP
Version 1 packets on an
interface, enter
1
.
To accept or send only RIP
Version 2 packets on an
interface, enter
2
.
To accept or send RIP Version
1 and Version 2 packets on an
interface, enter
1
and
2
separated with a space.
Set the RIP send and receive
mode on the interface. The
default is
talk-listen
.
ip rip
send-receive-mode
{talk-only | listen-only |
talk-listen}
talk
- transmits updates on
the interface and does not
receive them.
listen
- receives updates on
the interface and does not
transmit them.
talk-listen
- transmits and
receives updates on the
interface.