Filter
Top Products
MAGMA
Chapter 2 Installation 5
expansion chassis, refer to the separate Expansion Chassis User’s
Guide. Verify that the LED power indicator is ON.
IMPORTANT
When powering up, pay close attention to LEDs on the host card
inside the computer. Two LEDs must be
solid green before the
system will function properly. If both LEDs are not lit, you
may need to adjust the dip switch settings as described
below.
The PCIHIF68 (32-Bit PCI host interface card, labeled 01-03527-00)
includes a voltage switch in the top right corner of the board that may
need to be adjusted for proper installation. It is an easy process to
determine if the voltage switch needs to be adjusted for your
configuration.
1. If both LEDs shown below are lit, DO NOT adjust the dip
switch.
2. If only the +5V LED is lit (closed to the end of the board), shut
down your computer, then flip the switch to the ON position
before continuing. When you power up the computer again,
both LEDs should be lit.
STOP
DO NOT TURN ON THE MAGMA EXPANSION CHASSIS UNTIL
YOU HAVE SHUT DOWN YOUR HOST COMPUTER
COMPLETELY! It can cause a system lockup and loss of any
unsaved data.