Magma PE6RR Computer Hardware User Manual


 
MAGMA
6 Chapter 2 Hardware Installation
Connect cables to
the chassis.
Connect cables to
the host card.
When properly installed, each cable will have matching labels at both
ends (x1 to x1 and x3 to x3).
CAUTION
All cables attached to the expansion chassis must be securely
fastened. When you hear a “click,” it is properly secured. If not
securely connected, the connectors may cause intermittent or lost
connections.
Connect the power cord to the power-in receptacle located at the rear of
the enclosure.
NOTE
If at all possible, plug all power cords from the expansion chassis
and your host computer into a shared power strip, preferably one
that has surge and noise suppression circuitry built into it.
Recheck the Installation
Check your installation before powering up the Magma expansion
chassis for the first time. Although the power supply has an over voltage
protection device built into it, it may not "trip" in time to fully protect a
device that has been improperly connected, or whose power cable has
been damaged.
CAUTION
This product is provided with a power supply that automatically
adjusts to input voltages between 100 to 240 Vac. A U.S. and
Canadian 125 V power supply cord is provided with this product. If
using this product outside of the U.S. or Canada, please use locally
available power supply cords