Filter
Top Products
6
BIOS INSTALLATION (RAID SETTING)
Creating and deleting RAID sets is a function found in the BIOS (basic integrated operating
system). During boot up, the RAID setting message will appear and pause for a few moments
to allow you to choose what to do. This board will act as a normal non-RAID card when BIOS
is not configured for RAID. Just proceed to Software Installation.
Creating Striped Sets (RAID 0)
1. As the BIOS boots, press CTRL+S or F4 to enter the RAID BIOS utility.
2. Select "Create RAID set." Press Enter.
3. Select "RAID 0," then press Enter.
4. Select "Number of hard drive." Press Enter.
5. Select "RAID size." Press Enter.
6. Press Y to save your settings.
7. Press CTRL+E and then press Y to exit the setup.
8. Continue with conventional Fdisk and Format steps as if you were installing a conventional
hard drive.
9. Your RAID configuration is complete. Proceed to Software Installation.