Filter
Top Products
Regulatory Statements
FCC
This equipment has been tested and found to comply with FCC rules
Part 15, Subpart B § 15.109/15.107 Class B. Operation is subject to
the following two conditions:
• This device may not cause harmful interference; and
• This device must accept any interference received, including
interference that may cause undesired operation.
CE
This equipment is in compliance with the requirements of the following
regulations: EN 55022 Class B (2006); EN 55024 (1998+A1:2001+
A2:2003); IEC/EN 61000-3-2 (2006); IEC/EN 61000-3-3 (1995+A1
:2001+A2 :2005); (IEC/EN 61000-4-2 (1995+A1 :1998+A2 :2001)/-3
(2006)/-4(2004)/-5(2006)/-6 (1996+A1 :2001)/-11 (2004)
C-Tick
This equipment is in compliance with the requirements of the following
regulations: EN 55022 (2006); AS/NZS CISPR22 © IEC: 2005.EN 55022 (2006); AS/NZS CISPR22 © IEC: 2005.
VCCI
This equipment is in compliance with the requirements of the following
regulation: CISPR22 © IEC: 2005.
Important Pre-Installation Notes
• Unplug any USB 2.0 VGA adapter connected to your PC or notebook
computer before executing the Hi-Speed USB 2.0 DVI Converter
setup or un-installation program.
• An AC power adapter is required for an external USB hub. The driver
allows up to six Hi-Speed USB 2.0 DVI Converters on one PC.
• Connect the display device to the DVI connector of the Hi-Speed
USB 2.0 DVI Converter and switch the display device on before
plugging the converter into an available USB 2.0 port of the PC or
notebook computer.
• Do not reboot the computer until all USB 2.0 DVI Converters are
installed.
3
INTRODUCTION