Filter
Top Products
40
DECLARATION OF CONFORMITY
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device ma
y
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
U.S. Responsible Party:
Address:
Tel. No.:
Marantz America, Inc.
1100 Maplewood Drive,
Itasca, IL 60143, U.S.A.
630-741-0300
Type of Product:
Equipment Classification:
Models:
Plasma Display
Class B Peripheral
PD4230V/UIB, PD4250D/UIB, PD5050D/UIB, PD6150D/UIB
We hereby declare that the equipment specified above
conforms to the technical standards as specified in the FCC Rules.
*1 Only when using a graphic accelerator board that is capable of displaying 852ן480.
*2 PD4230V : Display only 400 lines with the screen center of the vertical orientation located at the center.
PD4250D : Display only 640 lines with the screen center of the vertical orientation located at the center.
PD5050D/PD6150D : This signal is converted to a 1024 dots ן 640 lines signal.
*3 The picture is displayed in the original resolution. The picture will be compressed for other signals (PD4230V/PD4250D).
*4 PD4230V : Aspect ratio is 5:4. This signal is converted to a 600 dotsן480 lines signal.
PD4250D : Aspect ratio is 5:4. This signal is converted to a 720 dotsן768 lines signal.
PD5050D/PD6150D : The aspect ratio is 5:4. This signal is converted to a 960 dotsן768 lines signal.
*5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the
RGB mode prepared for the input signals listed in the table above.
*6 To connect the monitor to Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer's video port.
*7 Other screen modes (ZOOM and STADIUM) are available as well.
*8 When viewing a moving picture at a vertical frequency greater than 65Hz, the picture may sometimes be unstable (jumpy).
If this occurs, please set the refresh rate of the external equipment to 60Hz.
To view 480I@60Hz (480 interlaced lines, 60Hz refresh rate) or 576I@50Hz (567 interlaced lines, 50Hz refresh rate)
when sync polarity is “Sync on Green”, set “RGB SELECT” to “MOTION”.
*9 CVT standard compliant.
NOTE:
• While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size of the picture or
the fine picture because of errors in synchronization of your computer.
• When a 1280 dots
ן
1024 lines signal or 1600 dots
ן
1200 lines signal is input to the monitor, the picture will be compressed (PD5050D/
PD6150D).
• PD4230V :
This monitor has a resolution of 853 dotsן480 lines. It is recommended that the input signal should be VGA, wide VGA, or equivalent.
PD4250D :
This monitor has a resolution of 1024 dots
ן
768 lines. It is recommended that the input signal should be XGA, wide XGA, or equivalent
.
PD5050D/PD6150D : This monitor has a resolution of 1365 dots
ן
768 lines. It is recommended that the input signal should be XGA,
wide XGA, or equivalent.
• With digital input some signals are not accepted.
• The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
• If you are connecting a composite sync signal, use the HD terminal.
•“IBM PC/AT” and “VGA” are registered trademarks of International Business Machines, Inc. of the United States.
•“Apple Macintosh” is a registered trademark of Apple Computer, Inc. of the United States.
• HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDM2 licensing
LLC.
04.9.2, 11:50 AM40