Filter
Top Products
16
ENGLISH
• Press the ZOOM button, the NORMAL button or the FULL button on the remote controller for the 4:3
aspect ratio video source.
• Press the FULL button on the remote controller for 16:9 aspect ratio video source, such as 1080i,
1035i, and 720p video systems.
• Press the FULL button on the remote controller for the squeezed video source.
The Screen Images in a 4:3 screen
❖ Original Source Image
❖ Full mode
The 16:9 squeezed image is displayed with the
correct aspect.
❖ Normal mode
❖ Zoom mode
16 : 9 video source
The 4:3 image is enlarged horizontally.
The picture in normal ratio 4:3 is displayed.
The picture in normal ratio 4:3 is enlarged
vertically and horizontally (with same ratio) to the
screen size
4 : 3 video source
❖ Through mode
It shows an image when the video source has the same resolution to RGB/video signal with 720 or less
vertical pixel number.
1. Press the STANDBY button on the remote controller or the / I button on the projector.
2. The fan continues running for about 1 minute to internally cool the projector. In the meantime, the ON
indicator on the projector flashes a blue color and buttons on the projector and remote control are
irresponsive to touch. Once the fan stops, the ON indicator goes out and the STANDBY indicator
lights up a red color to indicate the projector is on standby.
Notes :
- Do not pull out the AC power cord until the projector turns in standby mode.
- Do not pull out the power cord suddenly in the state of “POWER ON." It can cause a breakdown.
- When a WARNING indicator lit up or blinks in red, pull out the AC power cord after checking that the
fan has stopped.
- The projector will not be turned on if the ON button on the remote controller or the / I button on
the projector is pressed immediately after turning off. Press the ON button on the remote controller
or / I button on the projector after the projector turns into standby mode.
- When on standby, power to the projector is not OFF completely. If not planning to use the projector
for an extended period of time, unplug the AC power cord from AC power outlet as explained above.
MENUV-MUTE
ENTER
PATTERN
STANDBY ON
To Turn off the Power