Filter
Top Products
MM-5100 Windows Setup Manual 090803 NZ Page 2 of 44 4/09/2003
FCC RF EXPOSURE COMPLIANCE
In August 1996 the Federal Communications Commission
(
FCC
)
of the United States with
its action in Report and Order FCC 96-326 adopted an updated safety standard for
human exposure to radio frequency
(
RF
)
electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines are consistent with the safety standard
previously set by both U.S. and international standards bodies. The design of this device
complies with the FCC guidelines and these international standards.
Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or
attachments could impair call quality, damage the phone, or result in violation of FCC
regulations.
The use of this device in any other type of host configuration may not comply with FCC
RF exposure requirements and should be avoided. During operation, a 20cm separation
distance should be maintained between the antenna, whether extended or retracted, and
the user’s/bystander’s body (excluding hands, wrists, feet, and ankles) to ensure FCC RF
exposure compliance.
CAUTION
Change or modification without the express consent of Maxon Electronics Australia Pty.
Ltd. voids the user’s authority to use the equipment. This equipment has been tested and
found to comply with the limits pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in an appropriate
installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not used in accordance with instructions, can cause harmful radiation to radio
communication. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference in radio and
television reception, which can be determined by turning the equipment on and off, the
user is encouraged to try to correct the interference by one or more of the following
measures:
z Re-orient or relocate the receiving radio or TV antenna
z Increase the separation distance between the equipment and the receiver
z Contact RT Wireless Ltd. Technical Support for assistance.