Filter
Top Products
17
INSTALLATION
CABLE INSTALLATION (INTERFACE SPECIFIC)
RS232
9. Turn on the host system.
10. Scan the recall Recall Defaults bar code.
The Recall Defaults bar code is located in the MetroSelect Configuration Guide, under Need to Start Over
on
page xi (MLPN 00-02407x).
11. Configure the StratosS to match the host system’s RS232 parameters.
Refer to the MetroSelect Configuration Guide (MLPN 00-02407x) under Section G: RS232 for enabling RS232
Mode (scan the recall defaults bar code first).
Refer to the MS2x20 Stratos Series Scanner/Diva Scale Configuration Addendum (MLPN 00-02272x) for scale,
dual cable and single cable configuration bar codes.
xx** Specifies international connection. See the Base Kit Components and Optional Accessories section of this guide for a
complete listing.
See power source caution statement on page 10 of this manual.
Figure 18. RS232 Interface Cable Installation Schematic