Filter
Top Products
30
SCANNER OPERATION
IR ACTIVATION AREA (IR LED OUTPUT)
The StratosS’s default power save mode
†
is Dual Action Power Save Mode #2 (see page 36). This power save mode
†
turns
the laser OFF after a configured period of non-use then turns the motor OFF after thirty-minute intervals. Any movement
detected by the IR in the activation area, shown below in grey, will cause the scanner to exit the power save mode. The motor
will restart automatically and the laser will turn back on preparing the scanner for bar code recognition, decoding and
transmission.
Figure 29. IR Activation Area Perpendicular to Package Flow (IR LED Output)
†
Refer to the MetroSelect Configuration Guide (00-02407) for additional information on configurable power save modes.
Specifications are subject to change without notice.