Filter
Top Products
Page 14 - 34007532EN/AA
2. Installation
2.6 Connections
Check that the indications on the rating plate on the back of the UPS correspond to your AC-power system and to
the actual electrical consumption of all the equipment to be connected to the UPS.
1 - Remove the power cord supplying the
equipment to be protected.
2 - Pulsar EXtreme 2200C: connect the
power cord
(1)
just removed from the
equipment to the AC-power socket 7 and
then to the AC-power wall outlet.
- Pulsar EXtreme 3200C: connect the
supplied power cord 28 (250 V, 16 A) to the
AC-power socket 7 and then to the AC-
power wall outlet.
3 - Connect the protected equipment to the
UPS using the two cords 29 . It is advised to
connect priority loads to the four outlets 4
and any non-priority loads to the two
programmable outlets 5 (If the UPS is
connected to a computer running MGE UPS
SYSTEMS communications software, it is
possible to program the interruption of power
to the two programmable outlets 5 during
operation on battery power, thus reserving
backup power for the priority loads).
4 - Lock the connections using the securing
system 33 .
As soon as the UPS is energised,
the battery begins charging. Eight
hours are required to charge to the
full rated backup time.
(1) Make sure the cord has the following
characteristics: 250 V, 10 A, cross-sectional
area 1 mm
2
, type HO5.
7
4
29
28
5
33