Filter
Top Products
Page 16 - 3400753300/AE
22
17
17
The UPS goes to sleep mode at the end of the battery backup time, until complete shutdown, due to tripping of the
battery-protection function against deep discharge.
Return of AC input power:
IMPORTANT: If, in spite of the return of AC input power, the UPS does not restart, check that the automatic-restart
function (activated by return of AC input power) has not been disabled (see section 3.4).
The buzzer sounds continuously.
Press button 22 to turn the buzzer OFF.
The equipment is no longer supplied with power.
End of backup time
The low-battery warning threshold can be set by the user, with the UPS
Driver software (see section 3.4).
LED 17 flashes.
The buzzer beeps every three seconds.
There is very little remaining battery backup time. Close all
applications because UPS automatic shutdown is imminent.
Threshold for the low-battery warning
The AC-power source is outside tolerances, LED 17 is ON, the buzzer
beeps three times.
The equipment connected to the UPS is supplied by the battery.
Transfer to battery power
3.3 Operation on battery power (following an AC input power failure)
3. Operation
test
1
2
BYPASS
test
%
1
2
BYPASS
test
1
2
BYPASS