Filter
Top Products
www.mgeups.com
Network
Management Cards
User Manual
THE UNINTERRUPTIBLE POWER PROVIDER
Network Management Card
– User Manual 34003676EN/GA
Page
16/69
3.2.3.2 Battery measurements
3.2.3.3 By Pass measurements
3.2.4 UPS Control
Click on the “UPS Control” section in the menu.
If the UPS is not compatible with this function, a warning message is sent to the user.
UPS configuration may also prevent the commands from being properly run. Read the UPS manual for more
information.
This page enables triggering of startup and shutdown sequences for the UPS main output and Controlled
outlets.
Z The status of each output is displayed by a symbol associated with the Off label (red symbol) or Powered
(green symbol).
Z The shutdown sequences take into account the time required for the registered servers to shut down
without losing data (see shutdown parameters ). Once the sequence has started, the commands are
disabled until it ends.
Z After a startup sequence, the commands are disabled for 120 seconds to enable the servers to fully restart
B
y
Pass current
B
y
Pass volta
g
ePhase / Phase
Remainin
g
backu
p
time estimted b
y
the UPS
Batter
y
char
g
e level
Batter
y
volta
g
e
Batter
y
current – Ne
g
ative when dischar
g
in
g
Batter
y
tem
p
. – Internal tem
p
erature
p
robe