Filter
Top Products
2013 OPK Guide
7
Low-volume Installation Process
Follow these steps to install the OPK on individual target computers in a low-volume
environment. This procedure lets you install the default configuration of the OPK from the DVD
directly onto the target computer.
To perform a low-volume (default) installation
1. Insert the DVD into the DVD drive on the target computer.
2. Run oemsetup.ll-cc.bat on the computer to preload Office 2013:
oemsetup.ll-cc
where ll-cc is the two-letter abbreviation for the language and country or culture.
Administrator permissions are required to run the oemsetup.ll-cc.bat file.
3. Verify the installation by ensuring that all files were copied to
[FOLDERID_ProgramData]\Microsoft\OEMOffice15 on the target computer. For example,
c:\ProgramData\Microsoft\OEMOffice15.
High-volume Installation Process
Follow these steps to install the OPK on target computers in a high-volume environment. This
procedure lets you create a network installation point, optionally customize the configuration,
and install the configuration from the network installation point to the target computers.
If you plan to customize the installation, keep the following in mind:
To preload multiple languages, you simply preload each language individually by running
the appropriate oemsetup.ll-cc.bat file. Make sure that the languages you preload
match the languages that were preloaded for the operating system. If no language
matches those of the operating system, the user will be prompted to select a language.
If you preload Office 2013 to a location other than the default location, you must
perform these steps:
1. Copy the OPK DVD folders and files to a hard drive or a network share to which
you have Write permissions.
2. In the CoConfig.xml file, specify the custom preload folder for Office 2013
For example, c:\preload.
3. In oemsetup.ll-cc.bat, you must indicate that a custom preload location is being
used, and then specify the location. Update the following lines as shown: