Filter
Top Products
Installing the Modules
Installing 10/100Base-TX Modules
a.
Insert the RJ-45 connector on your cable into the socket
of the Module.
b.
Connect the other end of the cable to an appropriate
device with a 100Mbps Fast Ethernet or 10Mbps
Ethernet twisted pair interface.
c.
Power up the Switch.
Installing 100Base-FX Modules
a.
Remove the protective plastic covers from the fiber
connectors on the Module.
b.
Ensure that the Switch is powered up.
c.
Plug the ST (or SC) connector on the fiber cable into the
fiber socket on the Module.
d.
Connect the other end of the fiber optic segment to an
appropriate device fitted with a 100Mbps adapter.
Check the LED indicators on the front of the Switch to
ensure that the Module is operating correctly.