Filter
Top Products
IP CONTROL
27
About - Click About to verify the Client, Firmware, KME (Keyboard/Mouse
Emulation firmware) and Switch file versions installed on your IP Control.
Local Settings – Click Local settings, the Client Configuration box appears, see
Figure 23
Figure 23 Client Configuration box
Pointer type – From the Drop-down menu you can change the Client computer
mouse pointer to appear as a dot or to not appear at all.
Hide Toolbar – Check this option to hide the Toolbar from the next reconnection
onwards. To toggle the Toolbar on and off, press F9. See above page 19.
Full Screen Mode - Check this option to make the remote session screen appear in
full screen mode from the next reconnection onwards. To toggle the full screen
mode on and off, press F11.
23.11 Disconnecting the remote session
To disconnect the session, on the Toolbar, click . The Login box appears. You
can re-login or close the browser window.
24. Troubleshooting - Restoring factory defaults
Section 21 on page 17 explained how to restore factory settings from the Web
interface. When you cannot access the system e.g. you have forgotten the
Username or Password, you can restore factory defaults from the IP Control unit.
To restore factory defaults:
1. Press and hold down the Go-Local button for 3-4 seconds while powering up
the IP Control. The device boots up in safe mode.
2. Wait until the unit finishes booting.
3. Type into the Address box: http://IP address/config. (Do not start the address
with https). The Login box appears see Figure 24.