Filter
Top Products
15
English
Possible Cause
Symptom
What To Do
1. Plug the input power cord
into the AC wall outlet.
2. Once commercial power is
available recheck the LED.
3. Check the circuit breaker
at the service panel to see if
it is tripped.
4. Call for Service.
1. The input power cord is
not plugged into the AC wall
outlet.
2. No commercial power
available.
3. No AC voltage at the AC
wall outlet.
4. Internal charger fault.
The Charger Active
LED is not on.
1. Turn the DC circuit breaker
to the On position.
2. Reset the DC circuit
breaker.
3. Reconnect the internal bat-
tery wires.
4. Call for Service.
1. The DC circuit breaker
is in the Off position.
2. The DC circuit breaker
is tripped.
3. The internal battery wires
are disconnected.
4. Internal fault.
The DC Breaker On
LED is not on.
1. Plug the input power cord
into the AC wall outlet.
2. Set the dipswitch to the
correct setting.
3. Call for Service.
1. The input power cord is
not plugged into the AC wall
outlet.
2. The dipswitch is not set
to the correct input voltage.
3. The charger has an in-
ternal fault.
The charger is not
providing the correct
charge voltage.