IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
Page 4
WARNING: CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE
PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE
EQUIPMENT.
1.5 Safety
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important instructions for MCP SERIES series that SHOULD BE FOLLOWED DURING INSTALLATION
AND MAINTENANCE of the UPS and the batteries. The sound pressure level at the operator’s position is equal to or less than
60dB(A).
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK IN CONDITIONS WHERE LOAD EQUIP-
MENT GROUNDING CANNOT BE VERIFIED, DISCONNECT THE UPS FROM THE AC POWER OUTLET
BEFORE INSTALLING A COMPUTER INTERFACE CABLE. RECONNECT THE POWER CORD ONLY
AFTER ALL SIGNALING CONNECTIONS ARE MADE.
NOTICE: This equipment has been tested and found to comply with the limits for a Class A diigital
device, persuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instruction manual, may cause interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio
interference regulations of the Canadian Department of Communications.
Le présent appeil numérique n’emit pas de bruits radioélectroniques dépassant les limites applicables aus appareils
numérique de las Class A prescrites dans le Rélement sur le brouillage radioélectronique édicte par le ministerédés Com-
munications du Canada.
PARA SYSTEMS LIFE SUPPORT POLICY
As a general policy, Para Systems Inc. (Para Systems) does not recommend the use of any of its products in life support
applications where failure or malfunction of the Para Systems product can be reasonably expected to cause failure of the life
support device or to significantly affect its safety or effectiveness. Para Systems does not recommend the use of any of its
products in direct patient care. Para Systems will not knowingly sell its products for use in such applications unless it receives
in writing assurances satisfactory to Para Systems that (a) the risks of injury or damage have been minimized, (b) the customer
assumes all such risks, and (c) the liability of Para Systems Inc. is adequately protected under the circumstances.
Examples of devices considered to be life support devices are neonatal oxygen analyzers, nerve stimulators (whether used for
anesthesia, pain relief, or other purposes), autotransfusion devices, blood pumps, defibrillators, arrhythmia detectors and
alarms, pacemakers, hemodialysis systems, peritoneal dialysis systems, neonatal ventilator incubators, ventilators for both
adults and infants, anesthesia ventilators, and infusion pumps as well as any other devices designated as “critical” by the
United States FDA.
Hospital grade wiring devices and leakage current may be ordered as options on many PARA SYSTEMS UPS systems. PARA
SYSTEMS does not claim that units with this modification are certified or listed as Hospital Grade by PARA SYSTEMS or any
other organization. Therefore, these units do not meet the requirements for use in direct patient care.