Mitsubishi Electronics S290U Projector User Manual


 
EN 8
Battery installation
Use two AA size batteries.
1. Remove the back cover of the remote control by pushing the battery compartment door in the direction of the
arrow.
2. Load the batteries making sure that they are positioned correctly (+ to +, and - to -).
3. Replace the back cover.
Important:
Do not use a new battery with an old one.
Load batteries in the correct position.
Do not heat, take apart, or throw batteries into fire.
Do not try to recharge batteries. Do not use rechargeable batteries.
If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes
in contact with your eyes, rinse them with water and then consult your doctor.
Operation area (for wireless control system)
The range for operation is about 10 m when the remote control points to the projector. The distance to the screen
back to the projector must be less than 7 m. Depending on the type of the screen, the distance is different.
Important:
Avoid the direct sunlight or fluorescent light to the remote control sensor. Also keep the distance of more than 2 m
between the remote control sensor and fluorescent lamp on the remote control may not work correctly.
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
20˚
15˚
20˚
15˚
30˚30˚
20˚ 20˚
12 3
L
R
AUDIO
VIDEO
S-VIDEO
MAIN
AC IN
AUDIO OUT
VIDEO 1 INVIDEO 2 IN
COMPUTER OUT
AUDIO 2 IN
COMPUTER 2 IN
AUDIO 1 IN
COMPUTER 1 IN
OI
REMOTE
USB
RS-232C
When the remote control is connected with remote
control cable, it does not work as a wireless
remote control.
When you need a longer cable, use a pin-pin cable.
When using the wired remote control, the laser beam may be darker. It is normal.
Using the remote control