Mitsubishi Electronics SE2U Projector User Manual


 
Maintenance32
Lamp Information
Warning Message
When the Lamp indicator lights up red or a message appears suggesting it is time to
replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may break.
For more detailed information on lamp warnings, please refer to page 35.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too
hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp or Temp
indicator still lights up after turning the power back on, please contact your dealer.
Do not remove the lamp immediately after using the projector. You may get burned because
the lamp is very hot after use.
Before replacing the lamp, press the POWER button to turn off the lamp and wait for two
minutes for the lamp to cool down. Unplug the power cord from the wall outlet and wait one
hour for the lamp to cool down completely.
Do not remove the lamp except for replacement. Careless handling can cause injury or fire.
Do not touch the lamp directly. It may break and cause injury or burn.
Be sure not to drop the lamp lid screw into the projector. Also be sure not to put metal or any
flammable objects inside because it may cause fire or electric shock. If any objects should fall
inside, unplug and contact your dealer.
Install the lamp securely to prevent failure and fire.
If the lamp should break, small glass fragments may fall out through the grilles and some may
remain inside of the projector or the lamp box. When taking the lamp box out, be sure to turn
over the projector and hold the handle of the lamp box to avoid injury due to the glass
fragments.
If the lamp should break, never shake the lamp box or hold it in front of your face after
removing it. The glass fragments may fall out and cause injury to your eyes.
When placing the projector upside down to replace the lamp or conduct maintenance, ensure
that the projector is securely placed before working with it.
The lamp is fragile. If it is broken, be careful not to cut yourself with glass fragments.
Contact your dealer for a new lamp.
Interval of lamp replacement
The recommended interval of lamp replacement is about 2000 hours
*1
of consecutive use.
Such interval differs depending on the operating environment and may be shorter than 2000
hours
*1
. Decrease in luminescence and/or color brightness indicates that the lamp needs to
be replaced. When the lamp operation time exceeds 1500 hours
*1
, the lamp replacement
message will appear on the screen for 30 seconds
*3
every time the lamp is turned on. When
the lamp has been used for about 2000 hours
*1,*2
, the replacement message will flash in the
center of the screen for 30 seconds
*3
. (In such cases, the LAMP indicator lighting up red.)
The projector will shutdown after one minute.
*1 When Mode of the Picture menu is not set to Lamp Low mode continuously. When it is
set to Lamp Low mode, this duration will be extented.
*2 When Mode is set to Lamp Low mode, this duration will be extented to 2500 hours.
*3 The projector will not respond to any operations.