Filter
Top Products
EN-9
ENGLISH
Using the remote control
Operational range of the remote control
• Keep the remote control photo-sensor out of direct
sunlight or fl uorescent lamp light.
• Keep the remote control photo-sensor at least 2 m
away from fl uorescent lamps. Otherwise, the remote
control may malfunction.
• If there is an inverter-operated fl uorescent lamp
near the remote control, the remote control opera-
tion may become unstable.
• When you use the remote control too close to the
remote control sensor, the remote control may not
work correctly.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Front of projector
Rear of projector
Operate the remote
control within a distance
of 10 m from the projector,
pointing the light beam at
the remote control photo-
sensor (front or rear) of
the projector.
When operating the remote control, keep the
distance from the remote control to the projector
via the screen within about 7 m. The operable
range of the remote control, however, depends
on the characteristics of the screen.
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operation area.
• When the remote control is connected with remote control cable, it does not as a wireless remote control.
• When using the wired remote control, the laser beam may be darker. It is normal.
• When REMOTE OUT terminal on
this projector is connected to the
REMOTE IN terminal on the other
projector, the two projectors can
be controlled together by using
the remote control. (Up to two
projectors can be controlled.)
30°30°
30°30°
20°
5°
20°
5°
20°
20°
20°
20°
REMOTE IN
REMOTE OUT