Mitsubishi Electronics X70 Projector User Manual


 
EN – 10
Basic connections
This projector can be connected to equipment such as PC, VCRs, video cameras and DVD players.
Important:
Make sure that your equipment is turned off before connection.
Plug in firmly and unplug by holding the plug, not by pulling the AC power cord.
If connected units are set too close to one another, the image may be affected.
Refer to the user manual of each component for details of connections.
Projector + AV equipment
Important:
Match the color of video and audio plugs on the AV cable with the connections.
S-video signals take priority over video signals. If you input both S-video signals and normal video signals at
the same time, the normal video input automatically is inhibited.
VCR etc.
to S-video
input
to video
input
to audio
input
to S-video
output
to video
output
to audio
output
Connect either one of these.
Ferrite core
Speaker output is mono.
Select AUDIO MODE 2 to hear and to sound for the VIDEO. (Refer to page 16).
When connecting audio output of equipment which audio output is mono, connect to audio input L terminal.
Projector + DVD player or HDTV decoder
Some DVD players have output terminal for 3 line fitting (Y, CB, CR). When connecting them to the projector,
connect to COMPUTER IN of the projector. In this case, set “ Y, CB, CR” for COMPUTER INPUT setting in SIGNAL
menu.
DVD player generally has SDTV system component
video output (Y, CB, CR) terminals. HDTV decoder has
HDTV system component video output (Y, PB, PR) ter-
minals. When connecting the projector with DVD
player or HDTV decoder, the signal cuircuit
automaticaly applied to either of them. In this case,
the COMPUTER INPUT in the SIGNAL menu becomes
[Y, CB, CR/Y, PB, PR].
Y, PB, PR is an example of the terminal names for a HDTV decoder.
The terminal name is different depending on the connected equipment.
Use mini D-SUB 15 pin-BNC conversion cable for connection.
Some DVD players may not project the image correctly.
When connecting with HDTV equipment which has R, G, B output, set RGB for the COMPUTER INPUT in
the SIGNAL setting menu.
Change the setting in the SIGNAL menu, when 525p signal is inputted. (Refer to page 20).
B
G
R
C
B
(P
B
)Y C
R
(P
R
)
HD/CS VD
DVD player or HDTV decoder
No connection
to COMPUTER
IN
BNC-RCA connector
(optional)
Mini D-SUB 15 pin-BNC
conversion cable (optional)