Filter
Top Products
´ EN – 13
ENGLISH
To operate projector power ON
• The picture might not be of optimum performance
in extreme hot or cold conditions. (The projector is
not malfunctioning.)
4. Press the ZOOM/FOCUS button to FOCUS. “FO-
CUS” will appear on the display.
5. Adjust with the + or - button to get a fine picture.
6. Press the ZOOM/FOCUS button to ZOOM. “ZOOM”
will appear on the display.
7. Adjust with the + or - button to get an approximate
size.
• Focus and zoom adjustment is possible in the normal
picture mode only. In PinP or EXPAND mode, the
adjustment is prohibited.
8. Select the desired external input source by using
the COMPUTER or VIDEO button.
• The projector automatically selects the appropriate
signal format. The selected signal format is dis-
played on the screen.
• The COMPUTER or VIDEO button does not work
when MENU is displayed. At this time, the prohibi-
tion mark ( ) appeares on the screen.
• When selecting the COMPUTER input, the image
may flicker. Press the $ or % button to adjust the
image.
• The intensity of the lamp will be STANDARD for 1
minute regardless of the setting of the LAMP MODE
when the lamp turns on.
For X500U only
• To view the digital input, select COMPUTER 1 in-
put and set the INPUT SELECT switch on the ter-
minal board to DIGITAL.
1. Turn on the equipment connected to the projector.
2. Put the projector into standby mode by pressing the
main power switch. The POWER indicator lights up
red.
3. Turn the projector on by pressing the POWER but-
ton. The light source lamp starts warming up, even-
tually turning completely on.
• When the light source lamp does not light up,
wait until the LAMP indicator is turned off, then
press the POWER button again.
• If the main power switch to the unit is turned
off within two minutes of turning off the light
source lamp, power will not be applied to the
lamp for one minute when the next time the
main unit power switch is turned on. When
this happens, the indicator lamp will blink for
one minute.
condition
indicator
LAMP
POWER
stand-by
-
red
when light source lamp is on
green
green
light source lamp held off temporarily
red
-
Important:
• A darkened image may be seen right after pressing
the POWER button due to warming up of this pro-
jector. While warming up, no other commands can
be accepted.
• After the power is turned on or the LAMP MODE is
changed, the screen may flicker before the lamp op-
eration becomes stable. This is due to the charac-
teristics of the lamp, not a failure of the lamp.
• When the lamp indicator is blinking red, the ser-
vice life of the lamp is about to end. Replace the
lamp. See pages 23 and 26.
LAMP
VOLUME
ZOOM/
FOCUS
KEYSTONE
TEMP
VIDEO
COMPUTER
MUTE
AUTO
POSITION
MENU
ENTER
AUTO POSITION
button
AUTO POSITION
button
MUTE button
MUTE button
ENTER
RIGHT CLICK
LASER
COMPUTER
VIDEO
ZOOM/
FOCUS
KEYSTONE
VOLUME
AUTO
POSITION
MENU
P in P
MUTE
EXPAND STILL
2 , 11
REMOTE
AUDIO 2 INCOMPUTER 2 IN
AUDIO OUTCOMPUTER OUT
AUDIO 1 INCOMPUTER 1 IN
DIGITAL
ANALOG
INPUT SELECT
MAIN
AC IN
OI
L
R
S-VIDEO
VIDEO
AUDIO
VIDEO 1 IN VIDEO 2 IN
USB
RS-232C
3 , 9 , 10
3 , 9 , 10
8
8
8
4 , 6
4 , 6
5 , 7
5 , 7