Filter
Top Products
EN – 2
The lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert the user to the presence
of uninsulated “dangerous voltage” within
the product’s enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock.
The exclamation point within an equilat-
eral triangle is intended to alert the user
to the presence of important operating
and maintenance (servicing) instructions
in the literature accompanying the
appliance.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION:
TO PREVENT ELECTRIC SHOCK, DO NOT USE
THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS
THE BLADES CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
NOTE:
SINCE THIS PROJECTOR IS PLUGGABLE EQUIP-
MENT, THE SOCKET-OUTLET SHALL BE IN-
STALLED NEAR THE EQUIPMENT AND SHALL BE
EASILY ACCESSIBLE.
WARNING
Use the attached specified power supply cord. If you use
another power-supply cord, it may cause interference with
radio and television reception.
For X500U only
Use the attached RGB cable, RS-232C cable with this
equipment so as to keep interference within the limit of a
FCC Class A device.
For X490U / S490U only
Use the attached RGB cable, RS-232C cable with this
equipment so as to keep interference within the limit of a
FCC Class B device.
This apparatus must be grounded.
DO NOT LOOK DIRECTLY INTO THE LENS WHEN
PROJECTOR IS IN THE POWER ON MODE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
COUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
For X500U only
COMPLIANCE NOTICE OF FCC
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment gener-
ates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.This
digital apparatus does not exceed the Class A limits for radio
noise emissions from digital apparatus as set out in the interfer-
ence-causing equipment standard entitled “Digital Apparatus”,
ICES-003 of the Department of Communications.
Changes or modifications not expressly approved by Mitsubishi
could void the user's authority to operate this equipment.
COMPLIANCE NOTICE OF INDUSTRY
CANADA
This Class A digital apparatus complies with Canadian ICES-
003.
For X490U / S490U only
COMPLIANCE NOTICE OF FCC
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced Radio / TV technician
for help.
Changes or modifications not expressly approved by Mitsubishi
could void the user's authority to operate this equipment.
COMPLIANCE NOTICE OF INDUSTRY
CANADA
This Class B digital apparatus complies with Canadian
ICES-003.
When using the projector in Europe
COMPLIANCE NOTICE
This LCD - Video Projector complies with the requirements
of the EC Directive 89/336/EEC “EMC Directive” and 73/
23/EEC “Low Voltage Directive” as amended by Directive
93/68/EEC.
The electro-magnetic susceptibility has been chosen at a
level that gains proper operation in residential areas, on
business and light industrial premises and on small-scale
enterprises, inside as well as outside of the buildings. All
places of operation are characterised by their connection to
the public low voltage power supply system.
WARNING
Use the attached RGB cable or RS-232C cable with this
equipment so as to keep interference within the limits of a
EN55022 Class B. Please follow WARNINGS instructions.