Filter
Top Products
EN-11
1
Enter “9” and press the Enter key.
2
The setting screen is shaded and the setting is
updated.
It takes about 10 seconds for the setting to be •
updated. Don’t perform communication during
this period.
Save and exit
Because the password, display language, LAN control, and PJLink™ certification are set using the telnet •
function, you can also set them on the command prompt window of the personal computer. Enter the following
command and press the Enter key.
> telnet [IP address you set] 9999 [“>” shows a prompt.]
When setting menu appears, perform the setting procedure as described above.
(Note)
Check that the port number “9999” isn’t blocked by the firewall.
Preparation/SetUp (continued)
1
Enter “5” and press the Enter key.
When you don’t use PJLink™ protocol •
communication, skip this item. (See page 16 for
PJLink™.)
2
To enable the PJLink™ certification, enter “1” and
press the Enter key. To disable it, enter “0” and press
the Enter key. (Default is ON (1).)
Setting the PJLink™ certification (PJLink certification Mode)