Mitsubishi Electronics XL2550U Projector User Manual


 
EN-33
MENU ACCESS
FEATURE
opt.
LOCK
UNLOCK
OK
OK
PASSWORD
CONFIRM
1
3
24
O K : ENTER CANCEL : MENU
MENU ACCESS
FEATURE
opt.
LOCK
UNLOCK
OK
OK
PASSWORD
1
3
24
O K : ENTER CANCEL : MENU
Password function
This projector is equipped with the password function
that is designed for prevention of wrong operation by
children and restriction on operation by other than
specifi ed users.
DISPLAY INPUT ...........When the projector is turned
on, the startup screen (or splash screen) will ap-
pear and stay on the screen until the password is
entered. When the password is entered, the startup
screen will switch to the regular operation screen.
MENU ACCESS ........... All the buttons except for the
POWER button on the projector are disabled. (The
buttons on the remote control are enabled.) You
can use this mode as a measure of prevention
of wrong operation by children and restriction on
operation by other than specifi ed users.
SPLASH ID SCREEN ... IMAGE CAPTURE and SPLASH
SCREEN in the menu become unavailable. SPLASH
SCREEN will be set to ON automatically.
To enable the password function:
1. Display the FEATURE menu.
2. Press the
S
or
T
button to select PASSWORD
FUNCTION.
3. Press the W or X button to change the mode
among DISPLAY INPUT , MENU ACCESS and
SPLASH ID SCREEN .
When the password has already been set, the
mode won’t be changed. In such cases, press
the ENTER button to cancel the password func-
tion and try again.
4. Press the ENTER button.
The screen for setting the password function will
appear.
5. Press the ENTER button.
The screen for entering a password will appear.
6. Enter a 4 - 8 digit password using the
S
,
X
,
T
or
W
buttons on the remote control as shown below.
(
S
=1,
X
=2,
T
=3,
W
=4)
7. Press the ENTER button.
To cancel the procedure, press the MENU
button.
8. Enter the password again for confi rmation using the
same steps.
Advanced features (continued)
9. Press the ENTER button.
If the entered passwords don’t match, an error
message will appear.
To cancel the procedure, press the MENU
button.
To cancel the password function:
1. Display the FEATURE menu.
2. Press the
S
or
T
button to select PASSWORD
FUNCTION.
3. Press the ENTER button.
The screen for canceling the password function
will appear.
4. Press the ENTER button.
The screen for entering the password will
appear.
5. Enter a 4 - 8 digit password using the
S
,
X
,
T
or
W
buttons on the remote control as shown below.
(
S
=1,
X
=2,
T
=3,
W
=4)
6. Press the ENTER button.
If you enter a wrong password, an error message
will appear.
To cancel the procedure, press the MENU
button.
Important:
Disable the password by pressing the MENU and
ENTER buttons on the control panel at the same
time about three seconds.