Filter
Top Products
EN-37
POWER
Steady
gr een
or
Steady r ed
Steady r ed
Steady
g r een
Steady r ed
Steady r ed
Blinking
g r een/ r ed
Blinking
g r een/ r ed
S TA TUS
Blinking orange
Blinking g r een
Blinking g r een/ r ed
Blinking r ed
Steady r ed
O f f
Steady
or
Blinking
CONDITION
Abnormal temperatu r e
• The ventilation grilles a r e clogged with dust or dirt.
• The r oom temperatu r e is high.
The p r otection ci r cuit is working or the lamp is in an
abnormal condition.
The lamp cover isn ’ t closed.
Abnormal.
POSSIBLE SOLUTION
• Clean the ventilation grilles.
• Relocate the p r ojector to a cooler place.
• W ait until the S TA TUS indicator goes out,
then p r ess the POWER button.
• If the above solution is not e f fective,
replace the lamp.
Replace the lamp.
Change with a new lamp if this p r oblem
r ecurs.
Close the cover cor r ectl y .
Contact your deale r .
The lamp operation time exceeds the time elapsed until the
lamp shutdown notice while the power is on. (See page 38.)
The lamp operation time exceeds the time elapsed until the
lamp shutdown notice while the power is off. (See page 38.)
The lamp operation time exceeds the time elapsed until the
lamp shutdown. (See page 38.)
POWER
Steady
red
Steady
green
S TA TUS
Off
Steady
green
CONDITION
Stand-by
Lamp stand-by for power-on (about 1 minute)
The power is on. (Normal condition)
NOTE
The power cannot be turned off by pressing
the POWER button.
For the first one minute, the power cannot be
turned on by pressing the POWER button.
Steady
green
Blinking
Lamp stand-by for power-off (about 2 minutes)
r
green
Indicators
This projector has 2 indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problems persist, turn the projector off and consult your
dealer.
Normal condition
Abnormal condition
POWER indicator
STATUS indicator