Filter
Top Products
EDS-408A/405A Series User’s Manual Featured Functions
3-45
2. Configuring Email Settings
To configure the EDS’s email setup from the Console interface or browser interface, enter
your Mail Server IP/Name (IP address or name), Account Name, Account Password, Retype
New Password, and the email address(es) to which warning messages will be sent.
3. Activate your settings and test email if necessary
After configuring and activating your EDS’s Event Types and Email Setup, you can use the
Test Email function to see if your e-mail addresses and mail server address have been
properly configured.
Email Warning Events Settings
NOTE: The user interface for the EDS-408A shows 8 ports.
Event Types
Event Types can be divided into two basic groups: System Events and Port Events. System
Events are related to the overall function of the switch, whereas Port Events are related to the
activity of a specific port.
System Event Warning e-mail is sent when…
Switch Cold Start Power is cut off and then reconnected.
Switch Warm Start The EDS is rebooted, such as when network
parameters are changed (IP address, netmask, etc.).
Power Transition (OnÆOff) The EDS is powered down.
Power Transition (OffÆOn) The EDS is powered up.
Configuration Change Activated Any configuration item is changed.
Comm. Redundancy Topology
Changed
If any Spanning Tree Protocol switches have
changed their position (applies only to the root of the
tree).
If the Master of Turbo Ring has changed or backup
path is activated.
Authentication Failure An incorrect password is entered.