Filter
Top Products
CA-132/132I User’s Manual
2-4
When you wish to configure your Port 1’s I/O base address to 180, the DIP switch settings of panel
SW1 should be as follows:
When you wish to configure your Port 1’s INT Vector to 1C0, the DIP switch settings of panel SW2
should be as follows:
On On On Off Off Off On
0 × 1C0
The following diagrams show the DIP switch settings of panel SW1 and panel SW2 when the I/O base
address is configured to be 180, and the INT Vector is configured to be 1C0.
The diagram shown above is SW1 for
setting I/O Base Address.
The diagram shown above is SW2 for
setting INT Vector.
A3 A4 A5 A6 A7 A8 A9 Hex
On On On On Off Off On
0 × 180
A3 A4 A5 A6 A7 A8 A9 Hex