Filter
Top Products
CP-102U/UL User’s Manual Software Installation
3-46
F5 Group Edit
This is a convenient function that allows you to edit the configuration of several ports at one time
as a group.
Loading the Driver
After completing the setup procedure, run BIN\DP-DRV.EXE from the DOS prompt to load the
driver. The driver will automatically detect the boards that have already been installed. If one or
more board is detected, you will see a message similar the following:
Smartio/Industio Family DOS driver Version 1.5
Setup driver …
CP-102U/UL series (Bus= x ,Dev=y) : OK!
Device driver setup O.K.
This means that the CP-102U/UL Series driver has been installed properly. At this point, you may
execute applications that support API-232 functions, or start developing applications using the
API-232 library.
Unloading the Driver
To unload (release) the driver from memory, type DP-DRV/Q at the DOS prompt and then press
Enter.