Multitech MTPRI-HD30B Network Card User Manual


 
PRI Card User Guide
6 CommPlete Communications Server
Technical Specifications
The PRI card operating characteristics and specifications are provided below.
CPU Intel 960 (16 MHz RISC processor)
Dynamic RAM 4 Mb
Program Memory 512K bytes Flash
Serial I/O channels supported 23B + D on MTPRI-HD23B and
30B + D on MTPRI-HD30B
Serial I/O operation Simultaneous full duplex DMA (all
channels)
Diagnostic/status indicators 10 LEDs
Line Coding T1 - B8ZS or AMI (programmable), E1 HDB3
Framing T1 - ESF or D4 (programmable), E1 ESF
Capture Frequency T1 - 1.544 Mbps/E1 2.048 M +/- 200 bps
Input/Output Impedence T1 - 100 ohms/E1 120 ohms +/- 5%
Received Signal Level Range T1 - DSX-1 level to -27.5 db, E1 ITU G.703 to -43
Line Buildout T-1 7 levels (programmable) 0-320 meters, E1
short haul
Transitted Signal Level Range T-1 DSX-1 into 100 ohms, E1 G.703 into 120
ohms
Pulse Density and Zeroes Enforcement T-1 Per AT&T Pub 62411, E1 G.703/G.823
Line Loopback Set Inband Code (1000) repeating binary pattern
Line Loopback Reset Inband Code (100) repeating binary pattern
Interface Connector ISDN RJ-48C
Operating Temperature 0-55 degrees C (32-131 degrees F)
Relative Humidity to 90% without condensation
Dimensions: 9.2" H x 0.9 W x11.5 D (23.3 x 2.3 x 29.2 cm)
Power Requirements: +5V (+/-10%) 1.25 A
ISDN Signaling (PRI) Standards Q.921 and Q.931
Standards Supported National ISDN-2, AT&T 4ESS and 5ESS,
Northern Telecom DMS-250