Filter
Top Products
100
DataTalker Owner’s Manual
7.6 Composite Link Settings - Internal ISDN Terminal
Adapter
Table 7-6. Composite Link Settings - Internal ISDN Terminal Adapter
Step Procedure
1 Toggle DIP switch position 3 to the down (closed) position to enable the command port.
2 Connect a terminal or PC running communications software to the DATA/COMMAND
connector on the back panel of the DataTalker.
Note: Any cables connected to the computer should be shielded to reduce interference.
3 Apply power to the DataTalker.
4 Apply power to the terminal or PC. Run the PC’s communications software in terminal mode
and press ENTER twice to establish communications with the DataTalker. The Main Menu
appears:
Main Menu
1 - Configurations
2 - Statistics
3 - Reset Options
4 - Diagnostics
5 - Exit Command Mode
6 - QUICK SETUP
Selection : _
5 Enter 1 and press ENTER. The Configurations menu is displayed:
Configurations
1 - Data Port Configuration
2 - Voice/Fax Channel(s) Configuration
3 - Composite Link Configuration
4 - Factory Default Configuration Options
5 - Configure Remote Unit
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
6 Enter 3 and press ENTER to display the Composite Link Settings - Internal TA menu.
7 Select option 2, Configure TA, from the menu to verify the terminal adapter settings. After you
select the option, wait five seconds, then enter AT!V to access the terminal adapter’s
configuration menu. To change a setting, enter the menu choice number and press ENTER.
For further information refer to the ISDN Terminal Adapter Owner’s Manual.
Composite Link Settings - Internal TA
1 - On-Line XMT Rate: 128000
2 - Configure TA
3 - DOD/DOI: Off
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
8 When you are done configuring the terminal adapter, enter CTRL+X to exit the terminal
adapter’s configuration menu; then press ENTER, Q to return to the DataTalker’s Composite
Link Settings - Internal TA menu, and press M, ENTER to return to the Main menu.
9 Disconnect the terminal or PC from the command port and place DIP switch position 3 in the
up (OPEN) position to change the command/data port to a data channel.