Filter
Top Products
Cabling Instructions FaxFinder Cabling Guide
10 MultiTech Systems, Inc.
3. Connect FaxFinder to Ethernet Network.
Plug one end of your RJ45 ethernet cable into the FaxFinder’s
ethernet jack and the other end into your network ethernet hub.
This ethernet cable is not included with your FaxFinder unit.
Caution: Before connecting to the Ethernet Network, make
sure that the network to which you are connecting the
FaxFinder is not a 192.168.2.x subnet. Because the
FaxFinder’s factory default IP address is 192.168.2.1,
connecting it to a network that has a different device at
that same IP address would cause data interference.
If it is a 192.168.2.x subnet, connect from the
Administrative PC to the FaxFinder using an RJ45
crossover cable until the FaxFinder’s IP address has
been configured. Thereafter, connect the FaxFinder into
the network with an ordinary RJ45 cable.