Filter
Top Products
12 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD
Hardware Installation
Introduction
This section describes how to install the ISIHP server card into the
PCI bus on your personal computer, which involves
Opening your PC
Installing the card into the PC
Computer Requirements
Pentium-based PC or compatible with PCI bus architecture
Microsoft Windows 95, Windows 98, Windows NT version 4.0, SCO
Open Server version 5.0, Novell NetWare, or Linux
At least one floppy drive
800 blocks of hard disk space for UNIX, 100K bytes for Windows
NT, 34K bytes for Windows 95, 50K bytes for Novell
Shipping Contents
ISIHP card
RJ-45 ISDN cords (2 for ISIHP-2S/2U; 4 for ISIHP-4S/4U)
ISIHP Driver Disk set
ISDN TA Configuration Wizard disk
Quick Start Guide
User Guide (this online manual) on CD-ROM
Safety Warnings
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jacks are
specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Avoid using a telephone (other than cordless type) during an
electrical storm. There may be a remote risk of electrical shock from
lightning.