extremely light bobbin, easily causing the paper roll to go off
position when paper feeding with low remaining paper. In this
case, the paper near end sensor may function abnormally and it
would be a good solution to set in the setup window to have the
printer to send busy only when input buffer is full and not based
on every off line signal.
3.
Spacer plate
If the paper roll is of width less than the standard 80 / 58
mm, it may run away from the paper near end sensor during
application resulting in an error status. In this case, please stick
the spacer plate to the wall opposite to the paper near end sensor
in the paper roll compartment. Each spacer plate compensates 1
mm paper roll width shortage. There will be 1 spacer plate in the
accessory of the printer. If the user uses narrower paper roll and
requires more spacer plates, it can be purchased from Posiflex.
4.
Paper cutting
The paper advance after a protective cut is now set to 12
mm. In case the user uses direct cut instead of protective cut to
have something like a logo printed on top of each slip, it is also
highly suggested to print the logo and necessary paper feeding to
make 12 mm paper advance right after each cut to prevent curling
up and jamming of paper front edge inside the paper exit slot.
5.
Wall mount application
In wall mount application, the paper near end sensor will
not have proper operation and it is suggested to set in the setup
window to have the printer to send busy only when input buffer is
full and not based on every off line signal.
2 - 6