Filter
Top Products
ESC ‘p’ m n1 n2: Kitchen bell drive command (m = ‘0’,
0 n1 n2 255)
Hexadecimal codes are: 1B 70 m n1 n2
This command can be used to drive a kitchen bell
purchased from Posiflex when this printer is used as a kitchen
printer and the environment could be so noisy that the beeper for
reminding the kitchen staff of the printing can be not loud enough.
After fixing the kitchen bell onto say a kitchen wall, connect the
cable from the bell to the peripheral connector on the printer.
Then use this command with m set to 0 and both n1 and n2 set to
255. The printer will be able to drive the kitchen bell for about
half a second on each such command. If this command is sent to
the printer multiple times consecutively, the bell will ring for
about half a second and rest for also about half a second then ring
again for multiple times.
GS ‘p’ m n: Beep when cash drawer remain open (0 < m
< 256, n = ‘0’ or ‘1’)
Hexadecimal codes are: 1D 70 m n
If the cash drawer connected to the printer remains open for
more than m seconds, the printer beeps until the drawer is closed.
If m = 0, this function is disabled. The factory default of the
printer is set to disable this function. The parameter n in this
command identifies the way cash drawer indicates drawer open
status. n = ‘0’ (30H) applies to drawers giving an “open” signal
when cash drawer is opened. n = ‘1’ (31H) applies to drawers
giving a “short” signal when drawer is opened. Any value of the
parameters outside the defined range will cause the entire
command ignored.
5 - 6