G.
OPERATING ENVIRONMENT
• Place the printer on a sturdy, level surface.
• Choose a place that is well ventilated and free of
excessive dust, smoke or fume.
• Do not put the printer under direct sunlight or near a
heater.
• Ideal room temperature is from 5ºC to 40ºC. Ideal
humidity is from 20% to 85% RH (no condensation).
• Since the paper roll is highly thermal sensitive, please
keep them in a dark place that is 20º and 65% RH when
not installed in the printer.
• Use a grounded AC power outlet.
• Use only the power cord and power adaptor furnished
with the printer.
• Do not use a power outlet of a circuit shared with any
equipment that causes great electrical noise, such as
motors.
• Do not use a power outlet of a circuit shared with any
equipment that uses a lot of power, such as a copier or a
coffee maker.
• Do not touch any connector contacts to avoid possible
electrostatic damage.
• Do not allow the cut receipt to slide back into the cutter
during the operation. As this would lead to multiple
cutting at the lower edge of a receipt and the multiple
cut thin slips tend to cause mechanical malfunction.
1 - 5