Filter
Top Products
6.Change the input selection setting of the connector in the Input
Selection menu to "ADC".
Press Enter button to complete the setting and the menu closes.
7.Switch on the PC's power.
The monitor's power indicator will light up (blue).
If an image does not appear, refer to the "6. TROUBLESHOOTING" for advice.
Whenever finished, turn off the PC and the monitor.
* When turning on the monitor, the kid of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
* Adjust brightness of the screen depending on the brightness of your environment.
* Be sure to take adequate rests. A 10-minute rest period each hour is suggested.
* When changing the signal connector except ADC, open the Input Selection menu
again and change the setting to "Standard".
* To <Reset> the settings in ithe <Others> menu through ScreenManager, the
settings of Input Selection will revert to the default setting.
Two PCs can be connected to the monitor through DVI-I connector and D-sub mini 15
pin connector on the back of the monitor.
PC 1 PC 2