Filter
Top Products
English
16 2. CABLE CONNECTION
Selecting the active input
The Input signal selection button on the front panel can be used to select either Signal 1
or Signal 2 as the active input at any time. Every time the button is pressed, the input
changes. When switching the signal, the kind of the input signal (Signal1 or 2/Analog or
Digital) is displayed for a few seconds on the right top corner of the screen.
ENTER
AUTO
SIGNAL
1 - 2
The priority input signal
This function is used to select which PC will have priority to control the monitor when
utilizing two PCs. The monitor constantly checks the input signals and switches
automatically in accordance with the “Input Priority” setting (see table below). Once a
priority is set, whenever a change of signal is detected at the selected input, the monitor
will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically
detects and displays that signal.
Priority
setting
Performance
Signal 1
If signals from both inputs are present, the monitor gives preference to
Signal 1 in the following cases.
• When the power of the monitor is turned ON
• When the signal input to Signal 1 is changed even if active input was Signal
2.
Signal 2
If signals from both inputs are present, the monitor gives preference to
Signal 2 in the following cases.
• When the power of the monitor is turned ON
• When the signal input to Signal 2 is changed even if active input was Signal
1.
Manual
The monitor will not detect signals automatically in this mode. Select the
active input by pressing the input signal selection button on the monitor’s
front panel.
NOTE
• When the Signal 1 or Signal 2 is selected, the power saving mode of the monitor
activates only if both PCs are in power saving mode.
Input signal selection button