Filter
Top Products
English
4. ADJUSTMENT
21
4. ADJUSTMENT
4-1. Screen Adjustment
NOTE
• Allow the LCD monitor to stabilize for at least 20 minutes before making image
adjustments.
When connecting the DVI-I cable for digital input, see page 25.
Analog Input
Screen adjustments for the LCD monitor should be used in suppressing screen flickering
and also for adjusting the screen to its proper position. There is only one correct
position for each display mode. It is also recommended to use the ScreenManager
function when first installing the display or whenever changing the system. For
convenience, an easy set-up Program installed on the utility disk to assist in the set-up
procedure is provided.
Adjustment Procedure
1. Push the Auto adjustment button on the front panel.
The message “Your setting will be lost, if you press again now.” appears and
remains on the screen for 5 seconds. While the message is on the screen, push the
Auto adjustment button again to automatically adjust the clock, phase, screen
position and resolution. If you do not wish to do adjust the screen, do not push
the Auto adjustment button again.
If the appropriate screen can not be made by using the Auto adjustment
button, adjust the screen through the following procedures. If the
appropriate screen can be made, proceed to step 4.
2. Install the “Screen adjustment program”
Having read the “Readme.txt” file, install and run the “Screen adjustment
program” in the enclosed EIZO LCD utility disk. Step by step adjustment is
provided by the wizard guide.
NOTE
• If the user’s operating system has no utility disk (e.g. OS/2), we recommend
setting the desktop pattern to that as shown in the diagram on the following
page.