Filter
Top Products
8
1 INSTALLATION
D-Sub
mini 15 pin
MD-C87 (enclosed)
D-Sub
mini 15 pin
D-Sub 15 pin
Macintosh Adapter (Optional)
Macintosh
D-Sub
mini 15 pin
D-Sub
mini 15 pin
Standard PC graphics board
MD-C87 (enclosed)
1 INSTALLATION
Connecting the monitor to the PC
1)Be sure that the power switches of both the PC and the monitor are OFF.
2)Plug the signal cable into the connector at the rear of the monitor.
• When connecting the signal cable or cable adapter, first check that the shape at the
cable side matches the shape at the connecting side. After connecting, secure the
connection with the screw-in fasteners.
3)Plug the other end of the cable into the video connector on the rear of the PC. Refer
to the figures below.
Standard PC graphics board
Using the monitor with Windows 95/98
A monitor information file is in the EIZO utility disk enclosed with the package. It
includes all the required information for best operation with Windows 95/98.
Install the enclosed utility and select your model name from the monitor list in
Windows 95/98. For installation procedure, read the Readme file in the utilily disk.
Macintosh
An optional Macintosh adapter must be connected to the PC before connecting the
signal cable. Please consult EIZO dealer.
4)Plug the power cord into the power connector at the rear of the monitor. Then plug
the other end of the cord into a power outlet.
5)Turn on the monitor first, then the PC . The monitor’s power indicator will light up
(green). The monitor will warm up briefly, then display an image. Whenever
finishing your operation, turn off the PC and the monitor.
• If an image does not appear, refer to the “TROUBLESHOOTING” section on page
15 for an advice.