Filter
Top Products
© Copyright 2006 National Semiconductor Corporation 10 www.national.com
4.0 Software Installation and Operation
4.1 Installation
The CD provided in the LM95235 Evaluation Board Kit
contains the SensorEval software used to make the LM95235
Evaluation Board operate with the user’s PC. It is assumed
that the user will be using a PC with a Pentium® III or higher
processor and Microsoft Windows® XP/2000/98/ME
operating system.
The software is installed as follows:
1. Insert the SensorEval CD into the CD drive of the
PC. See details in the readme.txt file.
2. The software manual, provided on the CD, may be
useful to the user during this process.
3. Follow all of the Installation instructions in the
windows as the SensorEval software is installing.
4. The installation process will put an icon on the PC
desktop so that the SensorEval program will run
when the icon is double-clicked.
4.2 Operation
Follow the following procedure for operation the LM95235
Evaluation Board using the SensorEval software:
1. Run the SensorEval program by either double-
clicking on the icon on the desktop or by selecting
Start, Program Files, National Semiconductor,
SensorEval.
2. Plug in the USB cable on both the PC and the
LM95235 Evaluation Board.
Follow the register setup steps given in section 2.0 Quick Start
of this User’s Guide. Make sure that you are following the
given procedure for the specific evaluation board you are
working with.
Refer to the electrical schematic, layout and connector
diagrams for proper connections to external remote thermal
diodes.